The SME200L Vacuum Emulsifying Mixer from SinaEkato is a core production machine for cosmetic creams, pharmaceutical ointments and viscous emulsions. It integrates mixing, high-shear homogenization, temperature control and vacuum defoaming, and fully meets GMP and CE production standards.
Main Product Performance
The main tank is manufactured with SUS316L stainless steel and mirror polishing without sanitary dead corners. The three-layer jacket supports electric heating and circulating water cooling, with temperature adjustable from room temperature to 95℃ steadily. The scraper stirring runs at 0–60 rpm to prevent materials from sticking to the tank wall. The top high-shear homogenizer reaches 3000 rpm, breaking oil-water materials into tiny particles of 0.2–5 μm for ultra-stable emulsification. The vacuum pump can reach -0.09 MPa, completely eliminating bubbles and avoiding material oxidation. The PLC touch screen stores dozens of production formulas with full data recording. The hydraulic lifting cover simplifies tank opening, cleaning and material transfer, greatly improving batch efficiency. It can continuously process high-viscosity materials up to 50,000 cps with stable sealing and low failure rate.
Standard Operation Procedures
First, complete pre-operation inspection. Clean the tank and pipelines tightly, check the vacuum system, heating circuit and mechanical seal without leakage. Set the stirring speed, homogenizing speed and temperature on the PLC according to the production formula.
Second, feed raw materials. Preheat oil phase and water phase in the auxiliary tanks, then suck materials into the main emulsifying pot under negative pressure to avoid dust pollution.
Third, start the mixing process. Turn on the frame stirring first, then activate the high-shear homogenizer. Keep the vacuum value stable during emulsification until oil and water phases are fully blended. Maintain constant temperature to protect heat-sensitive active ingredients.
Fourth, finish defoaming and cooling. Keep vacuum for 5–10 minutes to remove residual air bubbles, then start water cooling until the material reaches the required discharging temperature.
Finally, release the vacuum to normal pressure, lift the tank cover and discharge finished products. Flush the tank with purified water immediately after production to keep the equipment hygienic for the next batch.
This 200L model balances fine emulsifying quality and large output. With simple standardized operation and reliable performance, it has become the preferred emulsifying equipment for medium-scale daily chemical and pharmaceutical factories.
Post time: Jun-26-2026
